Wiring duct,Cable Gland,Cable Tie,Terminals,RCCN

1. Do not pull the wiring harness too tightly (especially in the horizontal layout of the wiring harness), to avoid driving the vehicle in a bumpy state, causing the wiring harness fixed point position is wrong, resulting in an instantaneous distance between the two fixed points, Resulting in the wiring harness internal contact pull / virtual connection, wire parameters change, or even pull off the wire.

2. After the wiring harness is assembled, there should be enough clearance around it to ensure that it is not pressed by other parts and is not tripped by other parts and their fasteners. To avoid wiring harness insulation layer was caught, wear or rupture caused by grounding and other failures.
3. Not in the layout of the same type and color of the connector. To avoid misplaced, damaged harnesses and electrical appliances during assembly.
4. The connectors are arranged in an easily accessible position, arranged in a position where the hands and tools are easy to operate. In order to facilitate inspection, maintenance, in accordance with the actual assembly of electrical equipment to take into account the length of the wire. If the electrical parts installed in the surface easy to operate the location, you can save the wire directly to the connector connected to the parts; if the electrical installation location is more subtle, and the late maintenance and disassembly difficult, according to the need to electrical parts with the wire The length is appropriately increased, so that the arrangement of the connector is easy to check the maintenance position.
In the actual operation process, in addition to these five points in mind to harness assembly work, but also continue to find the problem, to develop more ways to solve the wiring harness assembly may occur hidden.